Wire.endTransmission(true) //true=send stopĪrduino addresses are 7 bit (excluding RW bit), so I2C byte address 0x40 needs to be changed to 0x20 for arduino functions. 0=success, 1=tx buff overrun, 2=NACK on address tx, 3=NACK on data tx, 4=other error If (Wire.endTransmission(false) = 0) //false=send restart (IMPORTANT-THIS ENDTRANSMISSION DOES NOT SEND STOP!). No need to send stop as done automatically Every version of the IDE has a library manager for installing Arduino software libraries. Today, there are three Arduino IDEs available: Arduino IDE 1.8.x (classic) Arduino IDE 2 (new). anyone can learn how to do it, with the help of the Arduino IDE. Uint8_t BytesReceived = Wire.available() //The slave can send less than was requested A wire is connected from a pin on the Arduino, to an LED via a resistor. Wire.requestFrom(0x5a, 2) //Address, no of bytes Result: 0=success, 1=tx buff overrun, 2=NACK on address tx, 3=NACK on data tx, 4=other error Uint8_t Result = Wire.endTransmission(true) //true=send stop Seems to be 7 bit value with bit0=lower bit (not I2C RW bit), so left shifted by 1 when sent over the wire.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |